Table of Contents
Advertisement
40–26
AUTOMATIC TRANSMISSION / TRANS
TRANSMISSION WIRE
REPLACEMENT
1.
REMOVE ENGINE UNDER COVER LH
2.
DRAIN AUTOMATIC TRANSAXLE FLUID
(a)
Remove the drain plug and gasket, and drain ATF.
(b)
Install a new gasket and drain plug.
Torque: 49 N m (500 kgf cm, 36 ft lbf)
2002 CAMRY REPAIR MANUAL (RM881U)
–
TRANSMISSION WIRE
3.
REMOVE AUTOMATIC TRANSAXLE OIL PAN
SUB–ASSY
(a)
Remove the 18 bolts, oil pan and gasket.
NOTICE:
Some fluid will remain in the oil pan. Remove all pan bolts,
and carefully remove the oil pan assembly.
(b)
Remove the 2 magnets from the oil pan.
C83111
(c)
Examine particles in pan.
(1)
Remove the magnets and use them to collect any
steel chips. Look carefully at the chips and particles
in the pan and the magnet to anticipate what type
of wear you will find in the transaxle.
Steel (magnetic): bearing, gear and plate wear
Brass (non–magnetic): bearing wear
AT0103
4.
DISCONNECT TRANSMISSION WIRE
(a)
Disconnect the 5 shift solenoid valve connectors.
(b)
Remove the bolt and lock plate, and disconnect the ATF
temperature sensor.
D25591
5.
REMOVE TRANSMISSION WIRE
(a)
Disconnect the transmission wire connector.
(b)
Remove the bolt and transmission wire.
C50009
Author :
Date :
4005V–02
2101
Advertisement
Table of Contents
