Table of Contents
Advertisement
20.
FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.1 RH
HINT:
Fully tighten the RH side by the procedures with the LH side.
22.
FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.2 RH
HINT:
Fully tighten the RH side by the procedures with the LH side.
23.
FULLY TIGHTEN STRUT ROD ASSY REAR
(See page 27–19)
24.
INSTALL STABILIZER BAR REAR
(See page 27–17)
25.
INSTALL EXHAUST PIPE ASSY CENTER
(a)
1MZ–FE engine: See page
(b)
2AZ–FE engine: See page
26.
INSTALL REAR WHEEL
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
27.
INSPECT REAR WHEEL ALIGNMENT(See page 27–3)
2002 CAMRY REPAIR MANUAL (RM881U)
REAR SUSPENSION
–
18.
STABILIZE SUSPENSION
(a)
Jack up the rear axle carrier, placing a wood block be-
tween them. Apply load to the suspension so that the
installed bolt of the suspension arm assy No. 1 (vehicle
side) is horizontally aligned with the center of the rear axle
hub.
C91813
19.
FULLY TIGHTEN REAR SUSPENSION ARM ASSY
NO.1 LH
(a)
Fully tighten the bolt.
Torque: 100 N m (1,020 kgf cm, 74 ft lbf)
HINT:
Keep the nut fixed while tightening the bolt.
C82996
21.
FULLY TIGHTEN REAR SUSPENSION ARM ASSY
NO.2 LH
(a)
Fully tighten the bolt.
Torque: 100 N m (1,020 kgf cm, 74 ft lbf)
HINT:
Keep the nut fixed while tightening the bolt.
C82997
15–5
15–2
REAR SUSPENSION ARM ASSY NO.1 LH
Author :
27–13
Date :
1946
Advertisement
Table of Contents
