Table of Contents
Advertisement
SST
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
SST
C93687
C93688
C91598
R00764
–
FRONT DRIVE SHAFT
(b)
Place SST onto the front axle inboard joint boot RH
clamp.
SST
09521–24010
(c)
Tighten the SST so that the front axle inboard joint boot
RH clamp is pinched.
NOTICE:
Do not overtighten the SST.
(d)
Using SST, adjust the clearance of the front axle inboard
joint boot RH clamp.
SST
09240–00020
Clearance: 1.9 mm (0.075 in.) or less
40.
INSPECT FRONT DRIVE SHAFT
(a)
Check to see that there is no remarkable play in the out-
board joint.
(b)
Check to see that the inboard joint slides smoothly in the
thrust direction.
(c)
Check to see that there is no remarkable play in the radial
direction of the inboard joint.
(d)
Check the boots for damage.
NOTICE:
Move the drive shaft assy keeping it level.
(e)
Make sure that the 2 boots are on the shaft groove.
(f)
Make sure that the 2 boots are not stretched or contracted
when the drive shaft is at standard length.
Drive shaft standard length: mm (in.)
1MZ–FE:
LH
RH
2AZ–FE:
LH
RH
Author :
576.9 " 2.0 (22.713 " 0.079)
895.4 " 2.0 (35.252 " 0.079)
591.2 " 2.0 (23.276 " 0.079)
890 " 2.0 (35.039 " 0.079)
Date :
30–17
1971
Advertisement
Table of Contents
