Table of Contents
Advertisement
SST
207 " 2.0 mm
(8.15 " 0.079 in.)
SST
SST
207 " 2.0 mm
(8.15 " 0.079 in.)
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
R10426
F40646
C91604
C91605
F40646
–
FRONT DRIVE SHAFT
(e)
Using SST, adjust the clearance of the large clamp.
SST
09240–00020
Crearance: 3.0 – 4.0 mm (0.118 – 0.157 in.)
(f)
Employ the same manner to the outboard joint small boot
clamp.
Crearance: 1.5 – 2.5 mm (0.059 – 0.098 in.)
35.
INSTALL FRONT DRIVE SHAFT DAMPER LH(M/T
TRANSAXLE)
(a)
Set the distance, as described below.
Distance: 207 " 2.0 mm (8.15 " 0.079 in.)
(b)
Make sure that the front drive shaft damper LH is on the
shaft groove.
(c)
Place SST onto the front drive shaft damper LH clamp.
SST
09521–24010
(d)
Tighten the SST so that the front drive shaft damper LH
clamp is pinched.
NOTICE:
Do not overtighten the SST.
(e)
Using SST, adjust the clearance of the front drive shaft
damper LH clamp.
SST
09240–00020
Crearance: 0.5 – 1.2 mm (0.020 – 0.047 in.)
36.
INSTALL
FRONT
RH(EXCEPT 1MZ–FE ENGINE TYPE)
(a)
Set the distance, as described below.
Distance: 207 " 2.0 mm (8.15 " 0.079 in.)
(b)
Make sure that the front drive shaft damper RH is on the
shaft groove.
Author :
DRIVE
SHAFT
Date :
30–15
DAMPER
1969
Advertisement
Table of Contents
