Table of Contents
Advertisement
4.
NOTICE FOR USING SWING ARM TYPE LIFT
(a)
Follow the instruction manual of the lift for a safe operation.
(b)
Use a cradle with a rubber attachment, as shown in the illustration.
(c)
Set in the vehicle so as to make its center of gravity as close as possible to the center of the lift. ("L"
becomes short.)
(d)
place the vehicle horizontally by adjusting the height of the cradle, and match the groove of the cradle
and the safety stand support location accurately.
(e)
Be sure to lock the swing arm during the operation.
(f)
Lift the vehicle up until the tires float, and shake the vehicle to make sure that the vehicle is stable.
5.
NOTICE FOR USING PLATE TYPE LIFT
(a)
Follow the instruction manual of the lift for a safe operation.
(b)
Use a plate lift attachment.
(c)
Be sure to set the vehicle to the specified position.
Right and left set position
Front and rear set position
(d)
Lift the vehicle up until the tires float a bit, and shake the vehicle to make sure that the vehicle is stable.
Swing Arm Type Lift
Plate Type Lift
B
A
2002 CAMRY REPAIR MANUAL (RM881U)
INTRODUCTION
S Place the vehicle over the center of the lift.
S Align the cushion gum ends of the plate with the attachment lower ends (A and C).
S Align the attachment upper end (B) with the rocker flange front side notch.
: CENTER OF VEHICLE
GRAVITY (unload condition)
Attachment
–
REPAIR INSTRUCTION
Center of Lift
L
100 mm (3.94 in.)
C
Author :
Rubber Attachment
Attachment Dimensions
85 mm (3.35 in.)
70 mm
(2.76 in.)
200 mm (7.87 in.)
Date :
01–19
D25021
19
Advertisement
Table of Contents
