Table of Contents
Advertisement
01–14
(g)
SEAT BELT PRETENSIONER
(1)
Never measure the resistance of the seat belt pretensioner (This may cause the seat belt preten-
sioner to activate, which is very dangerous).
(2)
Never disassemble the seat belt pretensioner.
(3)
Never install the seat belt pretensioner to another vehicle.
(4)
Store the seat belt pretensioner where the ambient temperature remains below 80°C (176°F)
without high humidity and away from electrical noise.
(5)
When using electric welding, first disconnect the connector (2 yellow pins) before starting work.
(6)
When disposing of a vehicle or the seat belt pretensioner alone, the seat belt pretensioner should
be activated before disposal (See page 61–9). Perform the operation in a safe place away from
electrical noise.
(7)
The seat belt pretensioner is hot after activation, so let it cool down sufficiently before disposal.
Never apply water to cool down the seat belt pretensioner.
(8)
Oil or water should not be put on the front seat outer belt, and the front seat outer belt should
not be cleaned with detergents of any kind.
Example:
(h)
AIRBAG SENSOR ASSEMBLY
(1)
Never reuse the airbag sensor assembly involved in a collision where the SRS has deployed.
(2)
The connectors to the airbag sensor assembly should be connected or disconnected with the
sensor mounted on the floor. If the connectors are connected or disconnected while the airbag
sensor assembly is not mounted to the floor, it could cause an undesired ignition of the supple-
mental restraint system.
(3)
Work must be started after 90 seconds from the time the ignition switch is turned to the "LOCK"
position and the negative (–) terminal cable is disconnected from the battery, even if only loosen-
ing the set bolts of the airbag sensor assembly.
(i)
WIRE HARNESS AND CONNECTOR
(1)
The SRS wire harness is integrated with the instrument panel wire harness assembly. All the con-
nectors in the system are in a standard yellow color. If the SRS wire harness becomes discon-
nected or the connector becomes broken due to an accident, etc., repair or replace it.
2002 CAMRY REPAIR MANUAL (RM881U)
INTRODUCTION
–
REPAIR INSTRUCTION
Author :
Date :
D26744
14
Advertisement
Table of Contents
