Check Airtightness In Fuel Tank And Filler Pipe; Inspect Fuel Cut Off Valve And Fill Check Valve; Check Air Inlet Line - Toyota 2002 Camry Service Manual

Hide thumbs Also See for 2002 Camry:

Table of Contents

EVAP Line Hose

EVAP Line Hose

2002 CAMRY REPAIR MANUAL (RM881U)

EMISSION CONTROL

If there is no abnormality, replace the fuel tank and filler pipe.

In the condition that the fuel is full, as the float value of the fill

check valve is closed and has no ventilation, it is necessary to

check the fuel amount (volume).

If there is no stuck in hoses, replace the fuel cut off valve and

fill check valve.

EMISSION CONTROL SYSTEM (2AZ–FE)

CHECK AIRTIGHTNESS IN FUEL TANK AND FILLER

Disconnect the EVAP line hose from the charcoal canister

side and then pressurize and make the internal pressure

in the fuel tank 4 kPa (41 gf/cm

Check that the internal pressure of the fuel tank can be

hold for 1 minute.

Check the connected portions of each hose and pipe.

Check the installed parts on the fuel tank.

Reconnect the EVAP line hose to the charcoal canister.

INSPECT FUEL CUT OFF VALVE AND FILL CHECK

Disconnect the purge line hose and EVAP line hose from

the charcoal canister.

Plug the cap to the air drain hose.

Pressurize 4 kPa (41 gf/cm

and check that there is ventilation through the EVAP line

Check if there is any struck in the vent line hose and EVAP

Reconnect the purge line hose and EVAP line hose to the

charcoal canister.

Disconnect the air inlet line hose from the charcoal canis-

Check that there is ventilation in the air inlet line.

Reconnect the air inlet line hose to the charcoal canister.

, 0.58 psi).

, 0.58 psi) to the purge port