Table of Contents
Advertisement
30–18
43.
INSTALL FRONT AXLE ASSY LH
(a)
Install the front drive shaft assy LH to the front axle assy LH.
NOTICE:
S
Be careful not to damage the outboard joint boot.
S
w/ ABS:
Be careful not to damage the speed sensor rotor.
45.
INSTALL TIE ROD ASSY LH
(a)
Install the tie rod assy LH to the steering knuckle LH with the nut.
Torque: 49 N m (500 kgf cm, 36 ft lbf)
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
41.
(a)
(b)
NOTICE:
C83851
HINT:
Whether the front drive inboard joint assy LH is in contact with
the pinion shaft or not can be known from the sound or feeling
when driving it.
42.
(a)
(b)
NOTICE:
Do not damage the oil seal.
C66548
44.
(a)
F40142
–
FRONT DRIVE SHAFT
INSTALL FRONT DRIVE SHAFT ASSY LH
Coat the spline of the front drive inboard joint assy LH with
ATF.
Aline the shaft splines and install the front drive shaft assy
LH with brass bar and hammer.
S
Set the snap ring with opening side facing downward.
S
Be careful not to damage the oil seal.
INSTALL FRONT DRIVE SHAFT ASSY RH
Using a screwdriver, install the drive shaft bearing bracket
hole snap ring.
Install the bolt.
Torque: 32.4 N m (330 kgf cm, 24 ft lbf)
INSTALL FRONT SUSPENSION ARM SUB–ASSY
LOWER NO.1 LH
Install the lower ball joint assy front LH to the front suspen-
sion arm sub–assy lower No. 1 LH with the bolt and nut.
Torque: 127 N m (1,295 kgf cm, 94 ft lbf)
Author :
Date :
1972
Advertisement
Table of Contents
