Table of Contents
Advertisement
Seal Packing
46.
INSTALL CHAIN TENSIONER ASSY NO.1
(See page 14–88)
Wire Harness
Rib
2002 CAMRY REPAIR MANUAL (RM881U)
ENGINE MECHANICAL
45.
INSTALL OIL PAN SUB–ASSY
NOTICE:
S
Remove any oil from the contact surface.
S
Install the oil pan within 3 minutes after applying seal
packing.
S
Do not start the engine 2 hours after installing.
(a)
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surface of the cylinder
6mm
block and oil pan.
(b)
Apply seal packing in the shape of bead (Diameter 3 – 4
mm (0.157 in.)) as shown in the illustration, and install the
oil pan.
Seal packing:
A52522
Part No. 08826–00080 or equivalent
(c)
Install the oil pan with the 12 bolts and 2 nuts.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
B12056
47.
INSTALL CRANK POSITION SENSOR
(a)
Install the bolt and crankshaft position sensor.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
(b)
Confirm the wire harness of the crank position sensor is
placed as shown in the illustration.
Clamp
A52071
48.
INSTALL CRANKSHAFT PULLEY
(a)
Install the crankshaft pulley (TMC made).
(1)
SST
(2)
Torque: 170 N m (1,733 kgf cm, 125 ft lbf)
SST
A52486
–
CHAIN (2AZ–FE)
Align the pulley set key with the key groove of the
pulley, and side on the pulley.
09213–54015 (91651–60855), 09330–00021
Using SST, install the pulley bolt.
Author :
14–85
Date :
1609
Advertisement
Table of Contents
