Table of Contents
Advertisement
01–6
Seal Lock Adhesive
(d)
GASKETS
(1)
When necessary, use a sealer on gaskets to prevent leaks.
(e)
BOLTS, NUTS AND SCREWS
(1)
Carefully observe all the specifications for tightening torques. Always use a torque wrench.
Medium Current Fuse and High Current
Fuse Equal Amperage Rating
Illustration
2002 CAMRY REPAIR MANUAL (RM881U)
INTRODUCTION
–
(c)
PRECOATED PARTS
(1)
(2)
(3)
Z11554
NOTICE:
Perform the torque checking with the lower limit value of
the torque tolerance.
(4)
(f)
FUSES
(1)
BE1367
Symbol
D27353
REPAIR INSTRUCTION
Precoated parts are bolts, nuts, etc. that are coated
with a seal lock adhesive at the factory.
If a precoated part is retightened, loosened or
caused to move in any way, it must be recoated with
the specified adhesive.
When reusing precoated parts, clean off the old
adhesive and dry the part with compressed air.
Then apply the specified seal lock adhesive to the
bolt, nut or threads.
Depending on the seal lock agent to apply, there
may be a case where it is necessary to leave it for
a specified time until it hardens.
When replacing fuses, be sure that a new fuse has
the correct amperage rating. DO NOT exceed the
rating, or use one with a lower rating.
Part Name
FUSE
MEDIUM CURRENT FUSE
HIGH CURRENT FUSE
Author :
Abbreviation
FUSE
M–FUSE
H–FUSE
V35001
Date :
6
Advertisement
Table of Contents
