Table of Contents
Advertisement
L1
L1
2.
FOR VEHICLES EQUIPPED WITH SRS AIRBAG AND SEAT BELT PRETENSIONER
HINT:
CAMRY is equipped with an SRS (Supplemental Restraint System), such as the driver airbag, front passen-
ger airbag, side airbag, curtain shield airbag and seat belt pretensioner.
Failure to carry out the service operations in the correct sequence could cause the supplemental restraint
system to unexpectedly deploy during servicing. It may lead to a serious accident.
Furthermore, if a mistake is made in servicing the supplemental restraint system, it is possible that the SRS
will fail to operate when required. Before servicing (including removal or installation of parts, inspection or
replacement), be sure to read the following items carefully. Then follow the correct procedure described in
this manual.
(a)
GENERAL NOTICE
(1)
Malfunction symptoms of the supplemental restraint system are difficult to confirm, so the diag-
nostic trouble codes become the most important source of information when troubleshooting.
When troubleshooting the supplemental restraint system, always check the diagnostic trouble
codes before disconnecting the battery (See page 05–690).
(2)
Work must be started after 90 seconds from the time the ignition switch is turned to the "LOCK"
position and the negative (–) terminal cable is disconnected from the battery.
(The supplemental restraint system is equipped with a back–up power source, so, if work is
started within 90 seconds after disconnecting the negative (–) terminal cable from the battery,
the SRS may deploy.)
When the negative (–) terminal cable is disconnected from the battery, memory of the clock and
audio systems will be cancelled. So, before starting work, make a record of the memorized con-
tents in each memory system. Then, when work is finished, reset the clock and audio systems
as before. To avoid erasing the memory in each memory system, never use a back–up power
supply from another battery.
(3)
Even in case of a minor collision where the SRS does not deploy, the horn button assembly,
instrument panel passenger airbag assembly, front seat airbag assembly, curtain shield airbag
assembly and seat belt pretensioner should be inspected (See pages 60–17, 60–34, 60–44,
60–50
and 61–9).
2002 CAMRY REPAIR MANUAL (RM881U)
INTRODUCTION
L2
D02612
L2
D01201
–
REPAIR INSTRUCTION
(i)
TORQUE WHEN USING TORQUE WRENCH WITH EX-
TENSION TOOL
(1)
When a SST or extension tool is combined with the
torque wrench to extend its entire length, if you
tighten until the reading of the torque wrench reach-
es the specified torque value, the actual torque be-
comes excessive.
(2)
In this manual, only the specified torque is de-
scribed. In case of using SST or extension tool, cal-
culate the reading of the torque wrench by the fol-
lowing formula.
(3)
Formula T'=T x L2/(L1 + L2)
Reading of torque wrench {N m (kgf cm, ft lbf)}
T'
Torque {N m (kgf cm, ft lbf)}
T
L1
Length of SST or extension tool (cm)
L2
Length of torque wrench (cm)
Author :
01–9
Date :
9
Advertisement
Table of Contents
