Table of Contents
Advertisement
14–114
SST
2002 CAMRY REPAIR MANUAL (RM881U)
ENGINE MECHANICAL
(c)
Using SST and a hammer, tap in a new guide bushing to
the specified protrusion height.
Protrusion height: 9.6 – 10.0 mm (0.3779 – 0.3937 in.)
SST
SST
(d)
Using a sharp 5.5 mm reamer, ream the guide bushing to
obtain the standard specified clearance between the
guide bushing and valve stem.
Standard oil clearance:
A36634
0.025 – 0.060 mm (0.00098 – 0.00236 in.)
21.
INSTALL EXHAUST VALVE GUIDE BUSH
(a)
Using a caliper gauge, measure the bushing bore diame-
ter of the cylinder head.
Diameter: 10.285 – 10.306 mm (0.4049 – 0.4057 in.)
(b)
Install the STD bushing if the diameter is within specified
diameter.
HINT:
STD
(c)
Using SST and a hammer, tap in a new guide bushing to
the specified protrusion height.
Protrusion height: 9.6 – 10.0 mm (0.3779 – 0.3937 in.)
(d)
Using a sharp 5.5 mm reamer, ream the guide bushing to
obtain the standard specified clearance between the
guide bushing and valve stem.
SST
Standard oil clearance:
A36635
0.030 – 0.065 mm (0.00118 – 0.00256 in.)
22.
INSPECT VALVE LIFTER
(a)
Check the lifter diameter.
(1)
Lifter diameter:
30.966 – 30.976 mm (1.2191 – 1.2195 in.)
P16860
(b)
Check the valve lifter oil clearance.
(1)
Lifter bore diameter:
31.009 – 31.025 mm (1.2208 – 1.2215 in.)
(c)
Subtract the lifter diameter measurement from the lifter
bore diameter measurement.
Standard oil clearance:
0.033 – 0.059 mm (0.0013 – 0.0023 in.)
A13374
Maximum oil clearance: 0.07 mm (0.0028 in.)
–
CYLINDER HEAD ASSY (2AZ–FE)
09201–10000 (09201–01050), 09950–70010
(09951–07100), 23801
10.333 – 10.344 mm (0.4068 – 0.4072 in.)
09201–10000 (09201–01050), 09950–70010
(09951–07100), 23801
Using a micrometer, measure the lifter diameter.
Using a caliper gauge, measure the lifter bore diam-
eter of the cylinder head.
Author :
Date :
1638
Advertisement
Table of Contents
