Table of Contents
Advertisement
30–2
ON–VEHICLE INSPECTION
1.
REMOVE FRONT WHEEL
2.
DISCONNECT FRONT DISC BRAKE CALIPER ASSY LH(See page 30–21)
3.
REMOVE FRONT DISC
6.
INSTALL FRONT DISC
7.
INSTALL FRONT DISC BRAKE CALIPER ASSY LH(See page 30–21)
8.
INSTALL FRONT WHEEL
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
9.
REMOVE REAR WHEEL
10.
DISCONNECT REAR DISC BRAKE CALIPER ASSY LH(DISC REAR BRAKE TYPE)
(See page 30–28)
11.
REMOVE REAR DISC(DISC REAR BRAKE TYPE)
12.
REMOVE REAR BRAKE DRUM SUB–ASSY(DRUM REAR BRAKE TYPE)
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
4.
(a)
If the backlash exceeds the maximum, replace the bearing.
F40163
5.
(a)
If the backlash exceeds the maximum, replace the axle hub.
F40164
13.
(a)
If the backlash exceeds the maximum, replace the axle hub as-
sembly.
C83015
–
DRIVE SHAFT, PROPELLER SHAFT, AXLE
INSPECT FRONT AXLE HUB BEARING BACKLASH
Using a dial indicator, check the backlash near the center
of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
INSPECT FRONT AXLE HUB DEVIATION
Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.)
INSPECT REAR AXLE HUB BEARING BACKLASH
Set a dial indicator near the center of the axle hub and
check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
Author :
3001V–02
Date :
1956
Advertisement
Table of Contents
