Table of Contents
Advertisement
30–24
18.
INSTALL LOWER BALL JOINT ASSY FRONT LH
(a)
Install the lower ball joint assy front LH and tighten the nut.
Torque: 123 N m (1,254 kgf cm, 91 ft lbf)
(b)
Install a new cotter pin.
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further up to 60_.
20.
INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH
(See page 30–8)
21.
INSTALL TIE ROD ASSY LH
(See page 30–8)
22.
INSTALL FRONT DISC
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
17.
(a)
F40155
19.
(a)
HINT:
Insert the bolt from the rear side of the vehicle and tighten the
nut.
(b)
C83023
NOTICE:
–
FRONT AXLE HUB SUB–ASSY LH
INSTALL FRONT AXLE HUB LH HOLE SNAP RING
Using snap ring plier, install a new front axle hub LH hole
snap ring.
INSTALL FRONT AXLE ASSY LH
Install the 2 bolts, nuts and front axle assy LH to the shock
absorber assy front LH.
Torque: 210 N m (2,141 kgf cm, 155 ft lbf)
Push the front axle assy LH toward the outside of the ve-
hicle, fit the splined part of the front drive shaft assy LH
to that of the front axle assy LH and insert the front drive
shaft assy LH into the front axle assy LH.
S
Do not push out the front axle assy LH excessively.
S
Be careful not to damage the outboard joint boot.
S
w/ ABS:
Be careful not to damage the speed sensor rotor.
Author :
Date :
1978
Advertisement
Table of Contents
