THERMOSTAT (2AZ–FE)
REPLACEMENT
1.
DRAIN COOLANT (See page 16–6)
3.
REMOVE THERMOSTAT
10_
5.
INSTALL WATER INLET
(a)
Install the water inlet with 2 nuts.
Torque: 9 N m (92 kgf cm, 80 in. lbf)
6.
ADD COOLANT (See page 16–6)
7.
INSPECT CHECK ENGINE COOLANT LEAK (See page 16–1)
2002 CAMRY REPAIR MANUAL (RM881U)
COOLING
2.
(a)
A59903
4.
10_
(a)
(b)
HINT:
The jiggle valve may be set within 10_ on either side of the pre-
scribed position.
B11281
–
THERMOSTAT (2AZ–FE)
REMOVE WATER INLET
Remove 2 nuts, and disconnect the water inlet from the
cylinder block.
INSTALL THERMOSTAT
Install a new gasket to the thermostat.
Install the thermostat with the jiggle valve upward.
Author :
16–11
1602X–02
Date :
1830