Table of Contents
Advertisement
32–28
Matchmarks
24.
INSTALL FRONT DISC
(a)
Aligning the matchmarks, install the front disc.
HINT:
When replacing the disc with new one, select the installation position where the disc has the minimum runout.
26.
TEMPORARY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
(a)
Temporarily tighten the bleeder plug to the disc brake cylinder.
27.
INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
28.
INSTALL PISTON SEAL
(a)
Apply the lithium soap base glycol grease on a new piston seal.
(b)
Install the piston seal to the disc brake cylinder.
2002 CAMRY REPAIR MANUAL (RM881U)
BRAKE
–
FRONT BRAKE
22.
INSPECT DISC THICKNESS
(a)
Using a micrometer, measure the disc thickness.
Standard thickness: 28.0 mm (0.433 in.)
Minimum thickness: 26.0 mm (0.039 in.)
F41542
23.
REMOVE FRONT DISC
(a)
Put matchmarks on the disc and the axle hub.
(b)
Remove the disc.
F41543
25.
INSPECT DISC RUNOUT
(a)
Temporarily fasten the disc with hub nuts.
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
(b)
Using a dial indicator, measure the disc runout 10 mm
(0.39 in.) away from the outer edge of the disc.
Maximum disc runout: 0.05 mm (0.0020 in.)
(c)
If the disc's runout is maximum value or greater, check the
bearing play in the axial direction and check the axle hub
runout (See page 30–2). If the bearing play and axle hub
C83569
runout are not abnormal, adjust the disc runout or grind
it on a "On–car" brake lathe.
Author :
Date :
2016
Advertisement
Table of Contents
