Table of Contents
Advertisement
30–14
SST
31.
INSTALL FRONT DRIVE SHAFT LH HOLE SNAP RING
(a)
Install a new front drive shaft LH hole snap ring.
SST
SST
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
30.
(a)
F41033
32.
(a)
C91588
33.
HINT:
Vinyl Tape
Before installing the boots, wrap the spline of the drive shaft
with vinyl tape to prevent the boots from being damaged.
(a)
(b)
W01994
34.
(a)
(b)
(c)
(d)
NOTICE:
Do not overtighten the SST.
R10425
–
FRONT DRIVE SHAFT
INSTALL FRONT DRIVE SHAFT DUST COVER LH
Using SST and a press, install a new front drive shaft dust
cover LH.
SST
09527–10011
INSTALL
FRONT
DEFLECTOR LH NO.2(W/O ABS)
Using SST and a press, install a new front wheel bearing
dust deflector LH No.2 until the distance from the tip of
front drive outboard joint shaft assy LH to the front wheel
bearing dust deflector LH No.2 reaches the specification,
as shown in the illustration.
SST
09387–00020
Distance: 13.5 – 13.8 mm (0.531 – 0.543 in.)
INSTALL OUTBOARD JOINT BOOT
Temporarily install a new outboard joint boot with 2
clamps to the drive shaft.
Pack the inboard joint shaft and boot with grease in the
boot kit.
Grease capacity:
1MZ–FE, 2AZ–FE(MT): 105 – 125 g (3.7 – 4.4 oz.)
2AZ–FE(AT): 100 – 120 g (3.5 – 4.2 oz.)
INSTALL FRONT AXLE OUTBOARD JOINT BOOT
CLAMP
Mount drive shaft in a soft vise.
Secure the 2 outboard joint boot clamps onto the boot.
Place SST onto the outboard joint large boot clamp.
SST
09521–24010
Tighten the SST so that the large clamp is pinched.
Author :
WHEEL
BEARING
Date :
DUST
1968
Advertisement
Table of Contents
