Table of Contents
Advertisement
Turn
7.
INSTALL THROTTLE BODY ASSY
(a)
Install a new gasket and the throttle body.
Torque: 20 N m (199 kgf cm, 14 ft lbf)
2002 CAMRY REPAIR MANUAL (RM881U)
ENGINE CONTROL SYSTEM
(b)
Install the sensor to the place where is at 20 – 30_ rotated
to the right from the specified installation position.
(c)
Gradually turn sensor counterclockwise until it touches
the throttle valve shaft, and temporarily tighten the 2 set
screws.
A59526
(d)
Connect the throttle position sensor connector.
(e)
Connect the hand–held tester or OBD II scan tool to the
DLC3.
(f)
Turn the ignition switch ON.
NOTICE:
After turning the ignition switch ON, do not depress the ac-
celerator pedal.
(g)
While reading the valve of the throttle valve opening per-
centage (THROTTLE POS) of the CURRENT DATA, turn
A59527
the throttle position sensor slowly to left and right and set
the sensor at the center value of the standard value, and
then tighten the screws.
Standard throttle valve opening percentage:
16.8 – 18.4 %
Torque: 2.0 N m (20 kgf cm, 18 in. lbf)
NOTICE:
After turning the ignition switch ON, do not depress the ac-
celerator pedal.
(h)
Recheck throttle valve opening percentage.
If the throttle valve opening percentage is not as specified, re-
peat step (g).
(i)
Perform fully closed throttle valve by hand and check that
the valve of the throttle valve opening percentage
(THROTTLE POS) of the CURRENT DATA stays with the
standard value.
Standard throttle valve opening percentage:
10 – 14 %
If the throttle valve opening percentage is not as specified, re-
peat step (g) to (i).
(j)
Paint the 2 set screws.
(k)
Turn the ignition switch OFF.
(l)
Disconnect the hand–held tester or OBD II scan tool from
the DLC3.
(m)
Disconnect the throttle position sensor connector.
–
THROTTLE BODY ASSY (1MZ–FE)
Author :
10–13
Date :
1443
Advertisement
Table of Contents
