Table of Contents
Advertisement
7.
REMOVE SKID CONTROL SENSOR(W/ ABS)
(See page 32–58)
8.
INSTALL SKID CONTROL SENSOR(W/ ABS)
(See page 32–58)
10.
INSTALL SKID CONTROL SENSOR WIRE(W/ ABS)
13.
INSTALL REAR DISC(DISC REAR BRAKE TYPE)
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
C83035
C83015
C83016
–
REAR AXLE HUB & BEARING ASSY LH
9.
INSTALL REAR AXLE HUB & BEARING ASSY LH
(a)
Install the rear axle hub LH & bearing assy LH with the 4
bolts.
Torque: 80 N m (816 kgf cm, 59 ft lbf)
11.
INSPECT BEARING BACKLASH
(a)
Set a dial indicator near the center of the axle hub and
check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
If the backlash exceeds the maximum, replace the axle hub as-
sembly.
12.
INSPECT AXLE HUB DEVIATION
(a)
Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 in.)
If the backlash exceeds the maximum, replace the axle hub as-
sembly.
Author :
30–29
Date :
1983
Advertisement
Table of Contents
