Table of Contents
Advertisement
22.
REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
23.
REMOVE REAR DISC
(a)
Put matchmarks on the disc and the axle hub.
(b)
Remove the disc.
24.
INSTALL REAR DISC
(a)
Aligning the matchmarks, install the rear disc.
HINT:
When replacing the disc with new one, select the installation position where the disc has the minimum runout.
25.
INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
27.
ADJUST PARKING BRAKE SHOE CLEARANCE(See page 33–21)
28.
TEMPORARY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a)
Temporarily tighten the bleeder plug to the disc brake cylinder.
29.
INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
30.
INSTALL PISTON SEAL
(a)
Apply the lithium soap base glycol grease on a new piston seal.
(b)
Install the piston seal to the disc brake cylinder.
31.
INSTALL REAR DISC BRAKE DISC BRAKE PISTON
(a)
Apply the lithium soap base glycol grease on the piston.
(b)
Install the piston to the disc brake cylinder.
2002 CAMRY REPAIR MANUAL (RM881U)
BRAKE
–
REAR DISC BRAKE
21.
INSPECT DISC THICKNESS
(a)
Using a micrometer, measure the disc thickness.
Standard thickness: 12.0 mm (0.472 in.)
Minimum thickness: 10.5 mm (0.413 in.)
F41554
26.
INSPECT DISC RUNOUT
(a)
Temporarily fasten the disc with hub nuts.
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
(b)
Using dial indicator, measure the disc runout 10 mm (0.39
in.) away from the outer edge of the disc.
Maximum disc runout: 0.15 mm (0.0059 in.)
(c)
If the disc's runout is maximum value or greater, check the
bearing play in the axial direction and check the axle hub
runout. (See page 30–2)If the bearing play and axle hub
F41556
runout are not abnormal, adjust the disc runout or grind
it on a "On–car" brake lathe.
Author :
Date :
32–35
2023
Advertisement
Table of Contents
