Table of Contents
Advertisement
(b)
Install a new cotter pin.
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further to 60_.
49.
INSTALL FRONT WHEEL
50.
ADD AUTOMATIC TRANSAXLE FLUID(A/T TRANSAXLE)(See page 40–1)
51.
INSPECT AUTOMATIC TRANSAXLE FLUID(A/T TRANSAXLE)
52.
ADD MANUAL TRANSAXLE OIL(M/T TRANSAXLE)
53.
INSPECT MANUAL TRANSAXLE OIL(M/T TRANSAXLE)
2002 CAMRY REPAIR MANUAL (RM881U)
DRIVE SHAFT / PROPELLER SHAFT
C83022
F40147
F40136
F40152
–
FRONT DRIVE SHAFT
46.
INSTALL SPEED SENSOR FRONT LH(W/ ABS)
(a)
Install the sensor wire and front flexible hose No.1 to
shock absorber with the bolt.
Torque: 18.8 N m (192 kgf cm, 14 ft lbf)
(b)
Install the sensor wire clamp.
(c)
Install the speed sensor front LH to the steering knuckle
LH with the bolt.
Torque: 8.0 N m (82 kgf cm, 71 in. lbf)
NOTICE:
S
Be careful not to damage the speed sensor.
S
Prevent foreign matter from being attached.
S
Do not twist the sensor wire when installing the sen-
sor.
47.
INSTALL FRONT STABILIZER LINK ASSY LH
(a)
Install the front stabilizer link assy LH with the nut.
Torque: 74 N m (755 kgf cm, 55 ft lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the stud.
48.
INSTALL FRONT AXLE HUB LH NUT
(a)
Install a new front axle hub LH nut.
Torque: 294 N m (2,998 kgf cm, 217 ft lbf)
(b)
Using chisel and hammer, stake the front axle hub LH nut.
Author :
30–19
Date :
1973
Advertisement
Table of Contents
