Table of Contents
Advertisement
01–16
(b)
REMOVING AND INSTALLING OF FUEL SYSTEM PARTS
(1)
Prepare a fire extinguisher before starting the operation.
(2)
For prevention of the static electricity, install a ground on the fuel changer, vehicle and fuel tank,
and do not spray much water so as to prevent slipping.
(3)
Never use any electric equipment like an electric motor or a working light as they may cause
sparks or high temperature.
(4)
Never use an iron hammer, as it may cause sparks.
(5)
Dispose of the shop rag separately from any fuel deposit.
Clamp Track
2002 CAMRY REPAIR MANUAL (RM881U)
INTRODUCTION
5.
(a)
(b)
(c)
D01563
6.
Spring Type Clamp
(a)
(b)
(c)
(d)
D25081
7.
(a)
(b)
(c)
D20025
(d)
(e)
–
REPAIR INSTRUCTION
REMOVAL AND INSTALLATION OF ENGINE INTAKE
PARTS
If any metal tip is mixed in the inlet pass, that may give a
bad effect to the engine and turbocharger.
When removing and installing the inlet system parts,
close the opening of the removed inlet system parts and
the engine with a clean shop rag or gummed tape.
When installing the inlet system parts, check that there is
no mixing of a metal tip.
HANDLING OF HOSE CLAMPS
Before removing the hose, check the clamp position to re-
store it securely.
Change a deformed or dented clamp into a new one.
In case of reusing the hose, install the clamp on the hose
where it has a clamp track.
For a spring type clamp, make adjustment by adding force
to the arrow mark direction after the installation.
FOR VEHICLES EQUIPPED WITH MOBILE COMMU-
NICATION SYSTEM
Install an antenna as far as possible away from the ECU
and sensors of the vehicle's electronic systems.
Install an antenna feeder at least 20 cm (7.87 in.) away
from the ECU and sensors of the vehicle's electronic sys-
tems. For details of the ECU and sensors locations, refer
to the section on the applicable component.
Prevent the antenna feeder from getting entangled with
the other wirings, and keep the antenna feeder separate-
ly from the other wirings as much as possible.
Check that the antenna and feeder are correctly adjusted.
Do not install any powerful mobile communication sys-
tem.
Author :
Date :
16
Advertisement
Table of Contents
