Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 365

A-2
HOW TO READ THE WIRING DIAGRAMS -
COMPOSITION AND CONTENTS OF WIRING DIAGRAMS
(1) This manual consists of wiring harness diagrams, installation locations of individual parts, circuits
diagrams and index.
(2) In each section, all specifications are listed, including optional specifications. Accordingly, some
specifications may not be applicable for individual vehicles.
Section Basic contents
Wiring harness Connector locations and harness wiring configurations on actual vehicles are illustrated.
configuration
diagrams
Single part Locations are shown for each point of relays, electronic control units, sensors, solenoids,
installation position solenoid valves, diodes, inspection connectors, spare connectors, fusible links, fuses, etc. In the
part's lists, parts are listed in alphabetical order.
Circuit diagrams Circuits from power supply to earth are shown completely, classified according to system. There
is a main division into power circuits, and circuits classified by system. The circuits classified by
system also include operation and troubleshooting hints.
D
D
D
D
D
D
Index All components used are listed by connector number and component name.
Junction block
The entire circuit for the junction block is described, because only the part of the junction
block needed is normally shown in each circuit diagram.
Joint connectors
The internal circuits for all joint connectors are described, because only the part needed
is shown in each circuit diagram.
Power supply circuits
Circuits from the battery to fusible link, dedicated fuses, ignition switch, general purpose
fuses, etc.
Circuits classified by system
For each system, the circuits are shown from fuse to earth, excluding the power supply
sections.
Operation
The standard operation of each system is briefly described, following the route of current
flow.
Troubleshooting hints
This is a brief explanation of the inspection points that serve as hints when troubleshooting.
Explanations of the circuits controlled by the electronic control unit are omitted. Refer
to the related publications as required.
Composition and Contents of Wiring Diagrams