Ethernet Switch; Power Up All The Talkswitch Units - Talkswitch CT.TS005.003902 User Manual

Check www.talkswitch.com/support for the latest updates.
TalkSwitch unit enclosures are not designed for stacking. We recommend
wall-mounting units to maximize airflow and keep the units from
overheating.

Ethernet switch

A switch provides direct communication between units, thus keeping the
voice-over-LAN data isolated from other data on the network.
1. Connect up to four units to the LAN switch.
2. Connect a computer to the phone system using the LAN connection or
directly to the unit through the USB or LAN port.
3. Power up and configure your units before adding any IP extensions that
will be part of the system. It is important that you place the IP
extensions on the same subnet as TalkSwitch.
Example: If your TalkSwitch unit has the IP address 192.168.1.200, your IP
extension should use IP addresses in the range 192.168.1.xxx that do not
conflict with other IP addresses.
Figure 16: Three units connected via a switch
E5 E6 E7 E8 L3
PF
MUSIC PA E1 E2 E3 E4 L1
E5 E6 E7 E8 L3
PF
MUSIC PA E1 E2 E3 E4 L1

Power up all the TalkSwitch units

Connect the provided AC adapters to each unit and plug the adapters into
available power outlets. Turn the units on by pressing the Power button on
the front of each unit. The lights on the front panels of the units will flash.
This means that they are powered up and connected to the LAN, but their ID
numbers are not set.
T A L K S W I T C H U S E R G U I D E
L4
L2 LAN USB POWER
L4
L2 LAN USB POWER
Internet
1 2
Reset
E5 E6 E7 E8 L3 L4
PF
MUSIC PA E1 E2 E3 E4 L1 L2
POWER
3 4
LAN USB POWER
2 3