Cables
Figure 254: Connecting the ODD SATA cable (B)
Ê Reconnect the new ODD SATA cable to system board connector SATA 5 (1).
Ê Run the ODD SATA cable through the cable clamps (see arrows) as shown
(2).
15.5.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section
page
70.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page
73.
396
"Connecting the server to the mains" on
Upgrade and Maintenance Manual
"Closing the server" on
TX120 S3