Removing The System Board - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

Ê If applicable, verify existing LAN teaming configurations as described in
section "Configuring LAN teaming" on page
Ê Locate the defective server as described in section
server" on page
Ê If applicable, ensure to note down your current network settings in the
operating system.
Ê Shut down the server as described in section
page 58.
Ê Disconnect the AC power cord from the system.
Ê Disconnect all external cables.
Ê Bring the server to its horizontal position.
Ê Remove the server cover as described in section
page 61.

14.4.3 Removing the system board

Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see section
I
Leave the processor on the defective board for now.
– Memory modules: refer to section
page 239
I
Ensure to take note of the memory modules' mounting positions
for reassembly.
– Expansion cards: refer to the section
page 180
I
Ensure to take note of the controllers' mounting positions and
cable connections for reassembly.
TX120 S3
50.
"Removing the processor heat sink" on page 248
Upgrade and Maintenance Manual
System board and components
83.
"Locating the defective
"Shutting down the server" on
"Opening the server" on
"Removing memory modules" on
"Removing expansion cards" on
349