After Replacing / Upgrading Lan Controllers; After Replacing The System Board; Switching Off The Id Indicator - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

5.2.17.1 After replacing / upgrading LAN controllers

Please note when re-using a replaced LAN controller:
Ê Confirm with the customer whether the LAN controller you have replaced
has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the LAN controller.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I
For details, refer to the relevant LAN driver manual.

5.2.17.2 After replacing the system board

Ê Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the system board.
I
For details, refer to the relevant LAN driver manual.

5.2.18 Switching off the ID indicator

Press the ID button on the front panel or use ServerView Operations Manager
to switch off the ID indicator after the maintenance task has been concluded
successfully.
I
For further information, refer to section
page 50 or to the "ServerView Suite Local Service Concept (LSC)"
manual.
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch off the ID indicators.
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View and press the Locate
button in the title bar to switch off the ID indicator.
TX120 S3
Upgrade and Maintenance Manual
Basic software procedures
"Locating the defective server" on
107