Processors
11.3.3 Removing the processor heat sink
Ê Remove the processor heat sink as described in section
processor heat sink" on page
11.3.4 Applying thermal paste
Ê Apply thermal paste as described in section
page
257.
11.3.5 Installing the processor heat sink
Ê Install the processor heat sink as described in section
processor heat sink" on page
11.3.6 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section
page
70.
Ê Reconnect the AC power cord to the power supply unit as described in
section
"Switching on the server" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
262
248.
259.
103.
Upgrade and Maintenance Manual
"Applying thermal paste" on
"Installing the
"Closing the server" on
77.
96.
"Removing the
"Enabling SVOM
"Enabling
TX120 S3