Software Configuration; Removing The Ufm Board; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

System board and components

14.2.1.5 Software configuration

The UFM delivery set includes the "Recovery Tool CD" to setup the VMware
ESXi configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.

14.2.2 Removing the UFM board

Field Replaceable Units (FRU)
Average task duration: 5 minutes

14.2.2.1 Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Removing the UFM:
●
– Phillips PH1 / (+) No. 1 screw driver

14.2.2.2 Preliminary steps

Before removing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the server as described in section
page 58.
Ê Disconnect the AC power cord from the system.
322
79.
50.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
TX120 S3