Hard disk drives / solid state drives
Only applicable for removing intact HDD / SSD modules:
Ê Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
7.2.4.3
Removing a 2.5-inch HDD / SSD module
Ê Remove the HDD / SSD module to be replaced from the server as described
in section
"Removing a 2.5-inch HDD / SSD module" on page
7.2.4.4
Installing a 2.5-inch HDD / SSD module
Ê Install the replacement HDD / SSD module into the empty drive bay as
described in section
7.2.4.5
Concluding steps
Perform the following procedures to complete the task:
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
Ê Install the hard disk drive cover as described in section
cover" on page
130
"Installing a 2.5-inch HDD / SSD module" on page
104.
71.
Upgrade and Maintenance Manual
126.
"Performing a RAID
"Mounting the drive
TX120 S3
123.