Concluding Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

10.4.5 Concluding steps

Perform the following procedures to complete the task:
Ê Close the server cover as described in section
page 70.
Ê Reconnect the AC power cord to the power supply unit as described in
section "Connecting the server to the mains" on page
Ê Update the system board BIOS to the latest version as described in section
"Updating or recovering the system board BIOS and iRMC" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê Enable the replaced memory module(s) as described in section
replaced components in the system BIOS" on page
Ê Verify if the memory mode has been restored to its original state as
described in section
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page 103
TX120 S3
"Verifying the memory mode" on page
Upgrade and Maintenance Manual
"Closing the server" on
73.
96.
96.
Main memory
86.
"Enabling SVOM
"Enabling
98.
"Enabling
243