11.2.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing and installing the processor heat sink:
●
– Phillips PH2 / (+) No. 2 screw driver
Removing and installing the processor: tool-less
●
11.2.2 Preliminary steps
Before upgrading or replacing the processor, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the server as described in section
page
58.
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section
page
61.
TX120 S3
79.
50.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
80.
"Locating the defective
"Shutting down the server" on
"Opening the server" on
Processors
247