Fujitsu PRIMERGY TX150 S6 Notes On Using

Thank you for purchasing our product. Before you start using your server, please
carefully read the additional notes described below.
1．Warning Messages of ServerView Remote Connector when start up the OS
[Symptom]
If following all conditions are met, the warning message below would be recorded on Application
Event Log when start up the server.
Type: Warning
Source: ServerView Remote Connector
Event ID:
Description:
Initialization not completed timely (0 seconds)
[Conditions]
1) ServerView Agent for Windows is installed
2) The system is highly-loaded for start up
[Cause]
Because the system is highly-loaded for start up, initializing process of ServerView Remote
Connector is delayed. This warning is to notify the service start up is not completed while certain
period of time. This message is not for failure notice of service start up.
[Remedy]
Even if the message is recorded because of the process delay as above, the service keeps running
the initializing process. The service will automatically start after complete the initializing process
of ServerView Remote Connector. No special handling is required.
* ServerView Remote Connector service is used as the service at the Performance Manager of ServerView.
Even though this service is not active, there is no effect to the function other than Performance Manager.
Note: how to confirm
Please follow the steps below to confirm ServerView Remote Connector service runs normally.
－ Start the Performance Manager from the ServerView S2.
－ Select the server of which you want to confirm the performance from the left side frame.
－ Select the <Report View> tab.
－ Select any report, and click the" Show >>" button.
If the graphics is displayed, ServerView Remote Connector service runs normally. Please use it without
any change. If the service is not a normal run, the dialog box as below will be displayed.
All Rights Reserved, Copyright© FUJITSU LIMITED 2008
Note on using PRIMERGY TX150 S6
0
1／8
CA92276-8243-01
June 2008
FUJITSU LIMITED