Basic Procedure - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
For further safety information, please refer to chapter
●
information" on page
In this chapter
- 2.5-inch HDD / SSD subsystem
"Installing 2.5-inch HDD / SSD modules" on page 121
●
"Removing 2.5-inch HDD / SSD modules" on page 125
●
"Replacing a 2.5-inch HDD / SSD module" on page 129
●
"Replacing SAS / SATA backplane" on page 143
●
- 3.5-inch HDD subsystem
"Installing 3.5-inch HDD modules" on page 132
●
"Removing 3.5-inch HDD modules" on page 137
●
"Replacing a 3.5-inch HDD module" on page 140
●
7.1

Basic procedure

- Solid state drives (SSDs) are always equipped before installing hard disk
drives.
- Hard disk drives / solid state drives with different capacities are installed
from highest to lowest capacity.
- Hard disk drives with different rotation speeds are installed from highest to
lowest speed.
- When installing hard disk drives with different bus technologies (SAS or
SATA), first install SAS drives and then SATA drives.
- Please refer to sections
mounting sequence.
- Install dummy modules into unused HDD / SSD bays.
120
37.
7.2.1 and 7.3.1
Upgrade and Maintenance Manual
for a complete overview of the
"Important
TX120 S3