Expansion cards and backup units
9.4.1.2
General instructions
Ê Place the controller on the mounting tabs on the slot bracket (1).
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws.
I
Use the following slot bracket for the ModularRAID controllers based on
LSI MegaRAID:
– Full height bracket perforated (preferred)
– Full height bracket not-perforated (if full height bracket perforated is
not available)
Figure 107: Perforated and non-perforated slot brackets
1
Full height bracket non-perforated
2
Full height bracket perforated
3
Low profile bracket perforated
I
For a more detailled description on how to install a slot bracket on a
controller, please refer to section
The slot bracket is removed in the reverse order of the installation.
216
Upgrade and Maintenance Manual
"Network adapter D2735" on page
217.
TX120 S3