Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

9.2.1.5

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
page 365.
9.2.1.6

Connecting a battery backup unit to the expansion card

Ê If applicable, connect a BBU to the expansion card as described in section
"Installing a BBU" on page
9.2.1.7

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server cover as described in section
page 70.
Ê If applicable, connect external cables to the expansion card.
Ê Reconnect the AC power cord to the power supply unit.
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 92.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
TX120 S3
188.
"Updating RAID controller firmware" on page
103.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Closing the server" on
"Enabling Option ROM scan" on
96.
107.
"Cabling" on
91.
"Enabling SVOM
"Enabling
179