Preliminary Steps; Installing The Tpm Board - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

System board and components

14.3.1.2 Preliminary steps

Before installing the TPM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the server as described in section
page 58.
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section
page 61.

14.3.1.3 Installing the TPM board

Figure 200: TPM kit
TPM kit (S26361-F3299-E2):
1 TPM module
S26361-D2727-A10
2 TPM spacers
I
Use the white TPM spacer (A3C40106008).
The black TPM spacer is not used in this server.
3 TPM special screw
C26192-Y10-C176
4 TPM bit insert for TPM special screw
334
79.
50.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Opening the server" on
TX120 S3