Cables
15.5.1 Required tools
Preliminary and concluding steps: tool-less
●
Replacing the ODD SATA cable: tool-less
●
15.5.2 Preliminary steps
Before replacing the power cable, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê Shut down the server as described in section
page
58.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the server cover as described in section
page 61
(rack server).
15.5.3 Removing the ODD SATA cable
Figure 251: Disconnecting the ODD SATA cable (A)
394
50.
"Disconnecting power cords" on page
Upgrade and Maintenance Manual
"Locating the defective
"Shutting down the server" on
"Opening the server" on
59.
TX120 S3