Standard Power Supply Unit; Replacing The Standard Power Supply Unit; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

Power supply
6.1

Standard power supply unit

6.1.1

Replacing the standard power supply unit

Field Replaceable Units (FRU)
Average task duration: 10 minutes
6.1.1.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the PSU:
●
– Phillips PH2 / (+) No. 2 screw driver
6.1.1.2

Preliminary steps

Before replacing the standard PSU, perform the following steps:
I
You are advised to perform this routine with the server in a horizontal
position.
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the server as described in section
page 58.
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section
page 61.
112
79.
50.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Opening the server" on
TX120 S3