Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the server cover as described in section
page 61
(rack server).
15.7.3 Removing the backup drive USB cable
Figure 263: Removing the backup drive USB cable (A)
Ê Disconnect the backup drive USB cable from system board connector USB1
DAT.
I
Notes on RDX drive USB cabling:
If the backup drive is connected via an USB 3.0 interface card,
disconnect the USB cable from the interface card.
TX120 S3
"Disconnecting power cords" on page
Upgrade and Maintenance Manual
"Opening the server" on
Cables
59.
405