Figure 158: Removing the installation bracket
Ê Remove installation bracket.
Ê Install the replacement ODD as described in section
drive (ODD)" on page
12.2.3.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the front cage as described in
Ê Close the server cover as described in section
page
70.
Ê Reconnect the AC power cord to the power supply unit.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX120 S3
265.
103.
Upgrade and Maintenance Manual
"Installing optical disk
"Closing the front cage" on page
"Closing the server" on
Accessible drives
68.
"Enabling
279