8.2.2
Replacing the HDD fan module for 2.5-inch version
I
Your system can be equipped with an additional air duct between the
HDD fan module and the SAS / SATA backplane. The procedure for
replacing the HDD fan module is the same as without the air duct
because the air duct can remain in place.
Figure 72: Position of the additional air duct
8.2.2.1
Required tools
Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
●
8.2.2.2
Preliminary steps
Before replacing the HDD fan module, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section
page
61.
Ê Open the front cage as described in section
page
66.
TX120 S3
50.
58.
Upgrade and Maintenance Manual
System fan and HDD fan
"Locating the defective
"Shutting down the
"Opening the server" on
"Opening the front cage" on
167