Preliminary Steps; Removing The Battery - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

14.1.2 Preliminary steps

Before replacing the CMOS battery, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê Shut down the server as described in section
page 58.
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section
page 61.

14.1.3 Removing the battery

Figure 185: Replacing the CMOS battery
Ê Press out on the locking spring to eject the depleted CMOS battery (1).
TX120 S3
50.
Upgrade and Maintenance Manual
System board and components
"Locating the defective
"Shutting down the server" on
"Opening the server" on
315