Replacing Sfp+ Transceiver Modules - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.2.3

Replacing SFP+ transceiver modules

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
For Fiber Channel over Ethernet (FCoE) configurations, the ethernet server
adapter is equipped with one or two SFP+ (small form-factor pluggable)
transceiver modules.
Required tools
Preliminary and concluding steps: tool-less
●
Removing SFP+ transceiver modules: tool-less
●
Removing SFP+ transceiver modules
Ê Remove the defective SFP+ transceiver module(s) as described in section
"Removing an SFP+ transceiver module" on page
Installing SFP+ transceiver modules
Ê Unpack the new SFP+ transceiver module.
Ê Verify that the new SFP+ transceiver module is the same type of transceiver
you are replacing.
Ê Install the replacement SFP+ transceiver module(s) as described in section
"Installing SFP+ transceiver modules" on page
Ê Inform the customer about changed WWN and MAC addresses.
I
By replacing SFP+ transceiver modules, WWN (World Wide Name)
and MAC (Media Access Control) addresses will change.
232 Upgrade and Maintenance Manual
230.
224.
TX120 S3