Preliminary Steps; Removing A 3.5-Inch Hdd Module - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

7.3.4.2

Preliminary steps

Before replacing a 3.5-inch HDD module, perform the following steps:
Ê Ensure that the HDD module to be removed is not combined into a RAID
array. If the drive is part of a RAID array, you first need to delete the array
using ServerView RAID Manager.
V
CAUTION!
All data on all HDDs in the array will be lost! Be sure to back up your
data before deleting a RAID array.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at
http://manuals.ts.fujitsu.com
http://jp.fujitsu.com/platform/server/primergy/manual/
market) or from the ServerView Suite DVD 2 supplied with your
PRIMERGY server.
Ê Shut down the server as described in section
page 58
Ê Remove the server cover as described in section
page 61
Ê Open the front cage as described in section
page 66.
Ê Locate the defective HDD module as described in section
indicators on the front" on page
Only applicable for removing intact HDD modules:
Ê Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
7.3.4.3

Removing a 3.5-inch HDD module

Ê Remove the HDD module to be replaced from the server as described in
section "Removing a 3.5-inch HDD module" on page
TX120 S3
(EMEA market) or
54.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Shutting down the server" on
"Opening the server" on
"Opening the front cage" on
138.
(Japanese
"Local diagnostic
141