Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual page 360

System board and components
Ê Reinstall the fan module as described in section
module" on page
Ê Close the server cover as described in section
page 70.
Ê Reconnect all external cables.
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D3049 BIOS Setup Utility for PRIMERGY TX140 S1 / TX120 S3 Reference
Manual".
Ê Reconnect the AC power cord to the power supply unit.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 86.
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section
information backup / restore" on page
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and the password.
V
CAUTION!
The system event log entry Chassis IDPROM: Restore
successful (see section
backup / restore" on page
board BIOS from version 1.15.0 or below to version 1.18.0 or above.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
360
158.
"Verifying system information
90) is not valid if you updated the system
103.
Upgrade and Maintenance Manual
"Installing the system fan
"Closing the server" on
"Verifying system
90.
96.
"Enabling SVOM
"Enabling
TX120 S3