Accessible drives
12.3.1.6 Concluding steps
Perform the following procedures to complete the task:
Ê Close the front cage as described in
Ê Close the server cover as described in section
page
70.
Ê Reconnect the AC power cord to the power supply unit.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page
12.3.2 Removing backup drive
Field Replaceable Units (FRU)
Average task duration: 10 minutes
12.3.2.1 Required tools
Preliminary and concluding steps: toolless
●
Removing accessible drives:
●
– Phillips PH2 / (+) No. 2 screw driver
12.3.2.2 Preliminary steps
Before installing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Remove any backup medium from the drive.
286
103.
79.
Upgrade and Maintenance Manual
"Closing the front cage" on page
"Closing the server" on
68.
"Enabling
82.
"Disabling BitLocker
TX120 S3