Replacing Expansion Cards; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

9.2.3

Replacing expansion cards

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
Note on network settings recovery
The following notes are required for TX120 S3p (PYT12Pxxx for Japanese
market).
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.2.3.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing expansion cards: tool-less
●
9.2.3.2

Preliminary steps

Before replacing an expansion card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê If applicable, verify existing LAN teaming configurations as described in
section "Configuring LAN teaming" on page
Ê Locate the defective server as described in section
server" on page
TX120 S3
79.
50.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Disabling BitLocker
80.
83.
"Locating the defective
"Disabling
183