Inserting The Backup Drive Filler; Concluding Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

Accessible drives

12.3.2.4 Inserting the backup drive filler

Figure 167: Inserting the backup drive filler cover
Ê Insert the backup drive filler cover.

12.3.2.5 Concluding steps

Perform the following procedures to complete the task:
Ê Close the front cage as described in
Ê Close the server cover as described in section
page 70.
Ê Reconnect the AC power cord to the power supply unit.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page
290
103.
Upgrade and Maintenance Manual
"Closing the front cage" on page
"Closing the server" on
68.
"Enabling
82.
TX120 S3