Figure 191: Installing the UFM board
Ê Connect the UFM board to the system board, snapping in the UFM spacer.
14.2.1.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section
page
70.
Ê Reconnect the AC power cord to the power supply unit.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX120 S3
103.
Upgrade and Maintenance Manual
System board and components
"Closing the server" on
96.
"Enabling SVOM
"Enabling
321